Machining Parameters
1. Rotational speed and feed rate are a guide for initial use.
2. To improve the machining result, take steps such as adjusting the rotational speed and feed rate, or try smaller chamfer sizes and increase them gradually to obtain the desired chamfer size.
3. If vibration or abnormal noise is detected, lower the rotational speed and feed rate, or try smaller chamfer sizes and increase them gradually to obtain the desired chamfer size.
4. If burrs are generated when machining plastics, maintain the feed per tooth as listed in the table and use the same rotational speed as the tool you normally work with.
XC-C-03-M / N
| Workpiece material | Copper | Stainless steel | Titanium alloy (Ti64) | Inconel | Aluminum alloys | Plastics |
| Coating | AlTiCrN | Uncoated | ||||
| Cutting speed (m/min) | 60-100 | 40-80 | 45-60 | 20-30 | 200-300 | 60-100 |
| Rotational speed (min-1) | 12000 | 9000 | 8000 | 4000 | 40000 | 12000 |
| Feed rate (mm/min) | 1800 | 1350 | 1200 | 600 | 6000 | 1800 |
| Feed per tooth (mm/tooth) | 0.05 | 0.05 | 0.05 | 0.05 | 0.05 | 0.05 |
XC-C-06-M / N
| Workpiece material | Copper | Stainless steel | Titanium alloy (Ti64) | Inconel | Aluminum alloys | Plastics |
| Coating | AlTiCrN | Uncoated | ||||
| Cutting speed (m/min) | 60-100 | 40-80 | 45-60 | 20-30 | 200-300 | 60-100 |
| Rotational speed (min-1) | 6300 | 4800 | 4000 | 2000 | 20000 | 6300 |
| Feed rate (mm/min) | 1260 | 960 | 800 | 400 | 4000 | 1760 |
| Feed per tooth (mm/tooth) | 0.05 | 0.05 | 0.05 | 0.05 | 0.05 | 0.07 |
