Cross Hole Types
The cross hole type of your workpiece is indicated in the Path Code Sheet to be provided separately. |
Type |
Description |
Configuration |
Edge Configuration |
Example |
---|---|---|---|---|
A |
Orthogonal Cross Hole - Outer Diameter (Cutter Insertion Hole < Outer Diameter) |
On-centerOff-center |
Upper/Lower |
▶ On-center & Off-center |
B |
Orthogonal Cross Hole - Inner Diameter (Cutter Insertion Hole ≦ Cross Hole) |
On-centerOff-center |
Upper/Lower |
▶ On-center & Off-center |
C |
Flat Surface Hole |
N/A |
Front/Back |
▶ Flat Surface Hole |
D |
Angled Cross Hole - Outer Diameter |
On-centerOff-center |
Upper |
▶ On-center ▶ Off-center |
E |
Angled Cross Hole - Inner Diameter |
On-centerOff-center |
Upper |
▶ On-center ▶ Off-center |
F |
Angled Surface Hole |
N/A |
Front/Back |
▶ Angled Surface Hole |
G |
Slotted Hole Parallel with Cross Hole Axis - Outer Diameter |
On-centerOff-center |
Upper |
▶ On-center ▶ Off-center ▶ Cross Hole Axis Aligned with X-axis |
H |
Slotted Hole Parallel with Cross Hole Axis - Inner Diameter |
On-centerOff-center |
Upper |
▶ On-center ▶ Off-center ▶ Cross Hole Axis Aligned with X-axis |
I |
Slotted Hole Perpendicular with Cross Hole Axis - Outer Diameter |
On-centerOff-center |
Upper |
▶ On-center ▶ Off-center ▶ Cross Hole Axis Aligned with X-axis |
J |
Slotted Hole Perpendicular with Cross Hole Axis - Inner Diameter |
On-centerOff-center |
Upper |
▶ On-center ▶ Off-center ▶ Cross Hole Axis Aligned with X-axis |
K |
Orthogonal Cross Hole - Inner Diameter (Cutter Insertion Hole > Cross Hole) |
On-centerOff-center |
Front/Rear |
▶ On-center & Off-center ▶ Cross Hole Axis Aligned |
L |
Broken Hole - Inner Diameter (Cutter Insertion Hole ≦ Cross Hole) |
Off-center |
- |
▶Off-center |
M |
Broken Hole - Inner Diameter (Cutter Insertion Hole > Cross Hole) |
Off-center |
- |
▶Off-center |
N |
Angled Cross Hole - Inner Diameter (Cutter Insertion Hole > Cross Hole) |
On-centerOff-center |
Front/Rear |
▶On-center ▶Off-center |
XEBEC Path for Tapped Hole
Type |
Description |
Configuration |
Edge Configuration |
Example |
---|---|---|---|---|
P |
Tapped Orthogonal Cross Hole - Inner diameter (Cutter Insertion Hole ≦ Cross Hole) |
On-centerOff-center |
Upper |
▶ Orthogonal Cross Hole |
Q |
Tapped Flat Surface Hole |
N/A |
Back |
▶ Flat Surface Hole |
R |
Tapped Angled Surface Hole |
N/A |
Back |
▶ Angled Surface Hole |